Let's talk about spa's

Anything and everything about Spa's and Hot tubs Q&A
 
HomeHome  Portal*Portal*  CalendarCalendar  GalleryGallery  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log in  Need Hot Tub Parts? Click here  
Welcome to our newest forum for those that was on the old forum we had to update the site so please re-register
Free spa / Hottub information and adivce
Spas & Hot Tub repair
Hot Tub & Spa Repair (813)779-9664
Like this topic?
Poll
Social bookmarking
Social bookmarking Digg  Social bookmarking Delicious  Social bookmarking Reddit  Social bookmarking Stumbleupon  Social bookmarking Slashdot  Social bookmarking Yahoo  Social bookmarking Google  Social bookmarking Blinklist  Social bookmarking Blogmarks  Social bookmarking Technorati  

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

Share | 
 

 Spa Heater Removal

View previous topic View next topic Go down 
AuthorMessage
K1
Admin
avatar

Posts : 66
Join date : 2009-07-08
Age : 52
Location : Tampa Bay

PostSubject: Spa Heater Removal   Sat Dec 18, 2010 4:58 pm





Spa Heater Removal
1. Turn off power to spa.
2. Open access panel to the equipment area.
3. Drain spa or close the gate valves (if equipped).
4. Open the control box and disconnect the heater power wires.
5. Disconnect the wires from the pressure switch and remove the sensor
6. Remove the bolts that secure the manifold to the control box.
7. Unscrew the pressure switch and slide out the high limit sensor. The pressure
switch is mounted on the heater manifold. The high limit sensor slides into the
sleeve on the heater.
8.Loosen the unions and remove heater manifold.

Installation Method:
1. Place the new heater manifold in the position of the old heater
2. Slide the high limit sensor in place on the heater manifold.
3. Tighten the two heater bolts that secure the heater manifold to the control box.
4. Connect the pressure switch wire and sensor wire to the circuit board.
5. Firmly tighten the heater element power leads to the heater terminals on the
circuit board.
6. Refill the spa through the filter and power up.
Back to top Go down
View user profile http://www.itsallaboutspas.com
 
Spa Heater Removal
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Hot Water Heater
» Heater problems: Marineland Pro Stealth has stopped shipping....
» Grass removal?
» Hot Water Heater Conversion kits
» under floor heater

Permissions in this forum:You cannot reply to topics in this forum
Let's talk about spa's  :: Troubleshooting Your Hot Tub :: Electric Heater Problems-
Jump to: