Let's talk about spa's
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Let's talk about spa's

Anything and everything about Spa's and Hot tubs Q&A
 
HomeHome  Portal*Portal*  GalleryGallery  SearchSearch  Latest imagesLatest images  RegisterRegister  Log in  Need Hot Tub Parts? Click here  
Welcome to our newest forum for those that was on the old forum we had to update the site so please re-register
Free spa / Hottub information and adivce
Spas & Hot Tub repair
Hot Tub & Spa Repair (813)779-9664
Like this topic?
Poll
Social bookmarking
Social bookmarking reddit      

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

 

 Topside Controls Troubleshooting Section

Go down 
AuthorMessage
K1
Admin
K1


Posts : 66
Join date : 2009-07-08
Age : 58
Location : Tampa Bay

Topside Controls Troubleshooting Section Empty
PostSubject: Topside Controls Troubleshooting Section   Topside Controls Troubleshooting Section EmptySat Dec 18, 2010 5:13 pm

Topside Controls Troubleshooting Section 58-138-1102_LG-182x165

No message or lights on control panel
Possible Causes Can Include:

Topside panel not plugged in.
Check connection point to make sure connection is tight.

Wrong topside control panel.
Make sure topside is common to equipment being controlled.

Topside control panel wire is damaged.
Check entire wire for damage. Rodents only need to bite the wire to make the
topside defective. Replace topside if necessary.

Topside control has no power.
Make sure incoming power is correct to spa. Plug in known good topside. If new
topside works, replace topside. If not, check transformer. If transformer is good,
replace circuit board.

Numbers are missing or blank
Check to make sure connection is clean, moisture and dirt will create problems
with the readout. Clean them carefully and re-plug topside back in.

Can’t read control panel at night
If topside has backlights, they may be burned out and need to be replaced.

Readout flickers during operation
Check for voltage problems, especially low voltage.
Back to top Go down
http://www.itsallaboutspas.com
 
Topside Controls Troubleshooting Section
Back to top 
Page 1 of 1
 Similar topics
-
» Air Venturi Troubleshooting Section
» Freeze Control Troubleshooting
» High Limit Troubleshooting Section
» Divertor Valve Troubleshooting Section
» Replacing your Spa Topside Control Panel

Permissions in this forum:You cannot reply to topics in this forum
Let's talk about spa's  :: Troubleshooting Your Hot Tub :: Digital/Electronic Spa/Hot Tub Equipment Control Problems-
Jump to: