Let's talk about spa's

Anything and everything about Spa's and Hot tubs Q&A
 
HomeHome  Portal*Portal*  CalendarCalendar  GalleryGallery  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log in  Need Hot Tub Parts? Click here  
Welcome to our newest forum for those that was on the old forum we had to update the site so please re-register
Free spa / Hottub information and adivce
Spas & Hot Tub repair
Hot Tub & Spa Repair (813)779-9664
Like this topic?
Poll
Social bookmarking
Social bookmarking Digg  Social bookmarking Delicious  Social bookmarking Reddit  Social bookmarking Stumbleupon  Social bookmarking Slashdot  Social bookmarking Yahoo  Social bookmarking Google  Social bookmarking Blinklist  Social bookmarking Blogmarks  Social bookmarking Technorati  

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

Bookmark and share the address of Let's talk about spa's on your social bookmarking website

Share | 
 

 Spa Pump Issues

View previous topic View next topic Go down 
AuthorMessage
K1
Admin
avatar

Posts : 66
Join date : 2009-07-08
Age : 52
Location : Tampa Bay

PostSubject: Spa Pump Issues   Sat Dec 18, 2010 4:42 pm

Does the pump shaft turn?

If NO, causes include:
Something could be stuck in the impeller. Take the wet end apart • and remove
obstruction.
Bearings may have locked up. If so, you will need to replace the pump / motor
assembly.
Ice in the wet end. If the weather is freezing, you need to allow it to thaw then
retry pump.

If YES, causes include:
Faulty capacitor. Change out the pump / motor assembly.
Faulty motor switch. Change out the pump / motor assembly.
Incorrect voltage. Make sure incoming voltage is correct
Pump makes a loud noise

Does the pump make a grinding noise?

If YES:
If pump - motor assembly is older, replace the bearings or replace the pump /
motor assembly
The impeller could be broken. If there is no water flow into spa, check impeller. If
the impeller is broken, replace it with a new one.
There may be an obstruction in wet end. Foreign objects will grind against
impeller. Open wet end and remove object.

Does the pump make a squealing or high pitched sound?

If YES:
Check whether something is rubbing against the shaft. Inspect the shaft by the
pump and remove any foreign objects.
Check for incorrect voltage. Too high voltage can make motor run too fast.
Check voltage and correct
Pump runs but water does not flow

Causes may include:
Pump is “air locked” See the Air Lock Section

Gate valves are closed. Pull up to open all the way to allow water to flow to pump.

Jets are turned off. Rotate jet inserts into the open position

Dirty or clogged filter. Clean filter or replace with new cartridge.

Impeller may be broken. Change defective impeller with new one.

Clogged pump. During fall, leaves can clog the pump. Clean out the pump and
impeller.

Obstruction in the line. If the drain line gets clogged, the pump cannot get water.
Check for obstruction and remove
Technical Information on
this page provided by
Cal Spas®,
This Section Covers Spa Pump Issues
Pump turns on and off frequently

When spa is in standard mode, if the pump turns on and off frequently, the sensor is trying to maintain the
spa’s temperature.
The water temperature sensor is +/- 1 degree accurate.
Switch to economy mode or check sensor for proper water sensor placement and insulation.
Pump runs Constantly

The circuit board may have been changed out recently. One of the most common mistakes during a circuit
board change out is a sensor that is plugged into the wrong place.
If another sensor is plugged into the freeze sensor point, the pumps will run constantly until the wrong
plug-in is corrected.
Check plug placement and change to proper pin.
If there was freezing weather during the delivery, the hi-limit / freeze sensor may have detected a possible
freeze condition and activated freeze control.
All pumps will continue to run on high speed until the freeze condition passes.
During this time, there will be no topside control over the pumps.
When the freeze condition passes, the pumps will automatically shut down and topside control will be
restored.
Back to top Go down
View user profile http://www.itsallaboutspas.com
 
Spa Pump Issues
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Outdoor Showers and other Gray Water issues
» Tomato issues
» Hatching Issues
» Is anyone else having issues with flies and gnats??
» Squash issues

Permissions in this forum:You cannot reply to topics in this forum
Let's talk about spa's  :: Troubleshooting Your Hot Tub :: Pump Issues, Jet Pumps-
Jump to: